Arduino MKRZERO - I2S bus & SD voor geluid, muziek & digitale audio data

Referentie
ABX00012
€ 37,50 € 30,99
2 in voorraad
Details
De MKR ZERO heeft een on-board SD houder en uitstekende SPI interfaces die je toelaten om muziek te spelen zonder extra hardware. Opgelet: deze werkt op 3.3V. Hogere spanningen op de I/O pins kunnen het bord beschadigen.
Meer informatie
Meer informatie
Referentie ABX00012
EAN code 02038062533608
Merk ARDUINO
Zolang de voorraad strekt Nee
Technische specificaties

(C) www.arduino.cc (only in English)

The MKR ZERO brings you the power of a Zero in the smaller format established by the MKR form factor. The MKR ZERO board acts as a great educational tool for learning about 32-bit application development. It has an on-board SD connector with dedicated SPI interfaces (SPI1) that allows you to play with MUSIC files with no extra hardware!  The board is powered by Atmel’s SAMD21 MCU, which features a 32-bit ARM Cortex® M0+ core.

Warning: Unlike most Arduino & Genuino boards, the MKRZero runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board.

The board contains everything needed to support the microcontroller; simply connect it to a computer with a micro-USB cable or power it by a LiPo battery. The battery voltage can also be monitored since a connection between the battery and the analog converter of the board exists.

You can find here your board warranty informations. 

Getting Started

In the Getting Started section, you can find all the information you need to configure your board, use the Arduino Software (IDE), and start to tinker with coding and electronics. 

Technical Specifications

Microcontroller SAMD21 Cortex-M0+ 32bit low power ARM MCU
Board Power Supply (USB/VIN) 5V
Supported Battery(*) Li-Po single cell, 3.7V, 700mAh minimum
DC Current for 3.3V Pin 600mA
DC Current for 5V Pin 600mA
Circuit Operating Voltage 3.3V
Digital I/O Pins 22
PWM Pins 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 -or 19)
UART 1
SPI 1
I2C 1
Analog Input Pins 7 (ADC 8/10/12 bit)
Analog Output Pins 1 (DAC 10 bit)
External Interrupts 8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 - or 17)
DC Current per I/O Pin 7 mA
Flash Memory 256 KB
Flash Memory for Bootloader 8 KB
SRAM 32 KB
EEPROM no
Clock Speed 32.768 kHz (RTC), 48 MHz
LED_BUILTIN 32
Full-Speed USB Device and embedded Host

* Ondanks een zeer uitgebreid voorraadsysteem, is het mogelijk dat de voorraadstatus niet overeenstemt met de actuele voorraad. Aarzel niet ons te contacteren, indien u zekerheid wenst over de beschikbaarheid. 

** De weergegeven foto bij de producten kan verschillen van het eigenlijke product.