Bouclier de prototypage Arduino PCB avec headers pour UNO
- Le circuit imprimé Arduino nécessite une carte Arduino.
- Carte Arduino 1.0
- Bouton de réinitialisation
- Carte SMD 14 broches
- Carte à trous débouchants 20 broches
- Carte SPI
- Grille longue et facile à souder
- Raillement 5V
| Référence | TSX00083 |
|---|---|
| code EAN | 02003309506349 |
| Marque | ARDUINO |
| Jusqu'à épuisement du stock | No |
SH: Schematics
Arduino Proto Shield is open-source hardware! You can build your own board using the following files:
Power
The Proto Shield bring the power from the Arduino standard IOREF and GND pins to the two power bus rows placed between the Through Hole prototyping are, which can be used for powering correctly your project independently on the chosen board (3V3 or 5V).
SPI Connection
On the ICSP connector only 5V and GND are wired to the respective pins on the header. MOSI and MISO are present only on the connector and on the near extra pads.
For more information about the SPI communication see the SPI library.
Physical Characteristics
The maximum length and width of the Proto Shield PCB are 2.7 and 2.1 inches respectively. Three screw holes allow the shield to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.
* Malgré un système de stock très étendu, il est possible que le stock ne correspond pas au stock actuel. Si vous voulez vérifiez le stock, n'hésitez pas de nous contacter.
** * La photo affichée peut différer du produit réel.