Adafruit Huzzah32 - ESP32 Feather board
Referentie
ADA3405
Details
- Dankzij deze breakout board kan je op een eenvoudige manier internet toevoegen aan je project. De ESP8266 processor is een 80MHz microcontroller met WiFi front end en TCP/IP stock met DNS suport. Een hele populaire chip, en dankzij deze breakout board ook gemakkelijk in gebruik door de 500mA 3.3V regulator.
Meer informatie
Referentie | ADA3405 |
---|---|
Merk | ADAFRUIT |
Zolang de voorraad strekt | Nee |
Technische specificaties
- 240 MHz dual core Tensilica LX6 microcontroller with 600 DMIPS
- Integrated 520 KB SRAM
- Integrated 802.11b/g/n HT40 Wi-Fi transceiver, baseband, stack and LWIP
- Integrated dual mode Bluetooth (classic and BLE)
- 4 MByte flash include in the WROOM32 module
- On-board PCB antenna
- Ultra-low noise analog amplifier
- Hall sensor
- 10x capacitive touch interface
- 32 kHz crystal oscillator
- 3 x UARTs (only two are configured by default in the Feather Arduino IDE support, one UART is used for bootloading/debug)
- 3 x SPI (only one is configured by default in the Feather Arduino IDE support)
- 2 x I2C (only one is configured by default in the Feather Arduino IDE support)
- 12 x ADC input channels
- 2 x I2S Audio
- 2 x DAC
- PWM/timer input/output available on every GPIO pin
- OpenOCD debug interface with 32 kB TRAX buffer
- SDIO controller/peripheral 50 MHz
- SD-card interface support
* Ondanks een zeer uitgebreid voorraadsysteem, is het mogelijk dat de voorraadstatus niet overeenstemt met de actuele voorraad. Aarzel niet ons te contacteren, indien u zekerheid wenst over de beschikbaarheid.
** De weergegeven foto bij de producten kan verschillen van het eigenlijke product.