Arduino Prototyping shield PCB
- Requires an Arduino board
- Arduino 1.0 pinout
- Large prototyping area
- Reset button
- 14 pin SMD footprint
- 20 pin through hole footprint
- SPI header
- long and easy to solder ground
- 5V rails
- Headers included
- For Arduino UNO
| Reference | TSX00083 |
|---|---|
| EAN code | 02003309506349 |
| Brand | ARDUINO |
| While stocks last | No |
SH: Schematics
Arduino Proto Shield is open-source hardware! You can build your own board using the following files:
Power
The Proto Shield bring the power from the Arduino standard IOREF and GND pins to the two power bus rows placed between the Through Hole prototyping are, which can be used for powering correctly your project independently on the chosen board (3V3 or 5V).
SPI Connection
On the ICSP connector only 5V and GND are wired to the respective pins on the header. MOSI and MISO are present only on the connector and on the near extra pads.
For more information about the SPI communication see the SPI library.
Physical Characteristics
The maximum length and width of the Proto Shield PCB are 2.7 and 2.1 inches respectively. Three screw holes allow the shield to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.
* Ondanks een zeer uitgebreid stocksysteem, is het mogelijk dat de voorraadstatus niet overeenstemt met de actuele voorraad. Aarzel niet ons te contacteren, indien u zekerheid wenst over de beschikbaarheid.
** De weergegeven foto bij de producten kan verschillen van het eigenlijke product.